Reach / push / load

CUSTOM EXCAVATOR FRONTS

Product family

SELECT THE WORKING PROFILE. THEN MATCH THE MACHINE.

For a custom excavator front, start with the carrier make, model and operating weight, then share the required reach and load case. Each configuration starts with the carrier interface and the material it must move, break, grip or process. Dimensions and wear protection are confirmed for the actual duty.

Engineered to carrier, reach and load case

Long-Reach Boom

Two- and three-section boom configurations extend the working envelope for deep or distant excavation.

Explore product

Custom shank count and machine match

Dozer Ripper

A reinforced rear tool for breaking hard soil and weathered rock.

Explore product

Machine-matched width and curvature

Dozer Blade

Robust blade structure with replaceable cutting edges and end bits.

Explore product

Custom capacity and cutting edge

Loader Bucket

General-purpose loader bucket geometry for dependable filling and material retention.

Explore product

Custom opening and machine match

Loader Log Fork

Wide fork geometry and an upper clamp control timber and roundwood.

Explore product

Custom capacity and discharge side

Side-Dump Bucket

Controlled side discharge supports work where forward dumping is constrained.

Explore product

13–22 t tracked host excavators · Reference passage 4.2 m W × 4.2 m H

Railway Wagon Unloading Gantry

A four-leg, twin-crawler straddle undercarriage raises a tracked excavator above an open railcar for direct transfer of coal, ore and other free-flowing bulk material into a haul truck.

Explore product